2000-2002 Nissan or Infiniti with No Start Problem
and DTC Store in ECM
Service Information
If a 2000-2002 Nissan or Infiniti has a one of the following conditions;
- Engine will not start with a Diagnostic Trouble Code
(DTC) of P1610/P1611 found stored in
Engine ECM
- MIL "On" with a Diagnostic Trouble Code (DTC) of P0605
found stored in Engine ECM
The cause may have been due to an incident of low battery voltage that had
occurred at some time
when the vehicle was being started. The condition of low battery voltage
might not be duplicated
during the dealer visit. Use the Service Procedure in this tip to repair
the incident, if it should occur.
Service Procedure
1. Ensure that the ECM
connector is fully seated and secured.
2. Fully charge the vehicle's battery.
3a. Erase the Engine ECM DTCs with CONSULT-II.
3b. If NATS DTC(s) were found stored in the ECM, then perform
C/U initialization and re-register all
customer NATS keys. See
ITB99-046 or NTB99-063 for information on C/U Initialization and
re-registration
procedures.
4. Verify incident condition has been completely resolved.
NOTE: Neither the ECM or NATS Immobilizer should be
replaced unless a DTC reoccurs AFTER the
above procedure or the vehicle is still unable to be started.
|