1. Fully open hood assembly.

2. Remove reservoir tank.

3. Remove radiator core support ornament.

3.1 To remove the mounting bolts on both sides of radiator core support ornament, first remove the mounting bolts of front bumper (shown by arrows in the figure) and pull up the bumper edge slightly to get working clearance.

3.2 Hold both sides of radiator core support ornament, pull it upwards and slide it to the rear of the vehicle.

3.3 Disconnect the harness clip and hood lock control cable clip on radiator core support.

4. Remove front grille mounting nuts (A).

5. Disengage pawls (A) of fixing front grille.

6. Pull front grille out toward vehicle front.

7. Remove the following parts after removing front grille.

Infiniti G35 / G37 Sedan DIY Projects
Modifications	Engine & Transmission	Air Bag & Body Exterior/Interior	Detailing
Electrical, Audio & Navigation	Heater & Air Condition	Suspension, ABS, Brakes & Tires	MIL & Engine Codes
Infinitihelp.com Knowledgebase
Infiniti G Sedan Bulletins	Infiniti G Sedan Campaigns/Recalls	Infiniti G Sedan Reference Specifications	Tips & Articles
Infiniti G Sedan Service Manuals	Infiniti G Sedan Owner's Manuals	Infiniti G Sedan Navigation System Manuals	Infiniti G Sedan Towing Guides
Infiniti G Sedan Warranty Booklets	Infiniti G Sedan Factory Accessories Installation Guides	Infiniti G Sedan Maintenance Schedules	Infiniti G Sedan Forums
Infiniti Repair Cost Estimator	Infiniti OBDII Code Chart	Glossary of Automotive Terms by HelpForCars.net