Infiniti >
G Sedan >
Heater & Air Condition
> In Cabin Micro Filter
Replacement Procedure
| |
| Project: |
In Cabin Micro Filter Replacement
Procedure |
| Models: |
|
| Part # |
|
| Tools |
- Phillips screwdriver
- Flat screwdriver
|
1. Remove the instrument lower passenger panels and glove box.
A. Carefully lift up
and remove the Passenger Side Front Door Sash Trim.
B. Remove Plastic Nut that secures the
Passenger Side Kick Panel
and remove
Kick Panel.
C. Remove the Lower Cover
(Under the Glove Box)
downward to access the Lower Glove Box Assembly
Mounting
Screws.
D. Remove the two Lower
Glove Box Assembly Screws
F. Open the Glove Box
Door and remove the four Upper Glove Box
Assembly Mounting Screws and the Glove Box Door Latch.
E. Move the Glove Box Assembly
2. Remove the filter cover, then remove the in-cabin
microfilter.
3. Take out the in-cabin microfilter from blower unit.
4. Replace with new one and reinstall on blower unit.
5. Reinstall the instrument lower passenger panel.
When installing a new microfilter make sure of the following:
- The filter is installed so that the arrow, on the end of the filter, is
facing the rear of the vehicle and is pointed upward.
- The microfilter sits on top of the two black plastic tabs, not behind them.
- The ledge on the back side of the microfilter cover panel slides below the
microfilter.
NOTE: If the microfilter is improperly installed, the ledge on the back
side of the microfilter cover panel pushes directly into the microfilter,
causing distortion. A distorted microfilter may interfere with the
recirculation door.
|
