1. Open the glove box.

2. Pull up glove box assembly (1)

3. Remove damper pin (2) of left side

4. Remove instrument lower assist panel.

• Remove instrument lower assist panel mounting screws (A) with power tool or screw driver.

• Pull back instrument lower assist panel (1).

• Disconnect harness connector.

5. Remove the filter cover, then remove the in-cabin microfilter.

6. Take out the in-cabin microfilter from blower unit.

7. Replace with new one and reinstall on blower unit.

8. Reinstall the instrument lower passenger panel.

When installing a new microfilter make sure of the following:

• The filter is installed so that the arrow, on the end of the filter, is facing the rear of the vehicle and is pointed upward.
• The microfilter sits on top of the two black plastic tabs, not behind them.
• The ledge on the back side of the microfilter cover panel slides below the microfilter.

NOTE: If the microfilter is improperly installed, the ledge on the back side of the microfilter cover panel pushes directly into the microfilter, causing distortion. A distorted microfilter may interfere with the recirculation door.

Infiniti G35 / G37 Sedan DIY Projects
Modifications	Engine & Transmission	Air Bag & Body Exterior/Interior	Detailing
Electrical, Audio & Navigation	Heater & Air Condition	Suspension, ABS, Brakes & Tires	MIL & Engine Codes
Infinitihelp.com Knowledgebase
Infiniti G Sedan Bulletins	Infiniti G Sedan Campaigns/Recalls	Infiniti G Sedan Reference Specifications	Tips & Articles
Infiniti G Sedan Service Manuals	Infiniti G Sedan Owner's Manuals	Infiniti G Sedan Navigation System Manuals	Infiniti G Sedan Towing Guides
Infiniti G Sedan Warranty Booklets	Infiniti G Sedan Factory Accessories Installation Guides	Infiniti G Sedan Maintenance Schedules	Infiniti G Sedan Forums
Infiniti Repair Cost Estimator	Infiniti OBDII Code Chart	Glossary of Automotive Terms by HelpForCars.net