Login  |  Register
CarZone Auto | Nissan and Infiniti Service Center
Search for Infiniti
Dealers Near You Infinitihelp.com
Local Dealers

  OBDII Codes Powered by
OBD2-OBDII Codes | Engine-Codes.com

P0475

P0475 - Exhaust Pressure Control Valve Malfunction

Possible causes
- Faulty Exhaust Back Pressure Valve
- Exhaust Back Pressure Valve harness is open or shorted
- Exhaust Back Pressure Valve circuit poor electrical connection
Tech notes
Check the Exhaust Back Pressure Valve (EBPV) butterfly valve is opening and closing freely and not sticking. If it seems to move freely you can then check the connector and circuit for the EBPV solenoid.
When is the code detected?
Problems with either the Exhaust Back Pressure (EBP) Device or the tube between the exhaust manifold and the EBP sensor can be detected during the exhaust back pressure step test, in which the Engine Control Module (ECM) commands and then measures a specific preprogrammed pressure and then measures time for pressure decay during the engine running test.

If the ECM detects an Exhaust Back Pressure (EBP), Engine Oil Temperature (EOT) or Intake Air Temperature (IAT) sensor fault it will disable the exhaust back pressure regulator.
Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P0475 Description
Exhaust Back Pressure Regulator - Is a variable position valve that controls exhaust back pressure during cold ambient temperatures to increase cab heat and decrease the amount of time needed to defrost the windshield. The Engine Control Module (ECM) uses the measured exhaust back pressure, (ambient) intake air temperature, engine oil temperature and engine load to determine the desired exhaust back pressure. Valve position is controlled by switching the output signal circuit to 12 volts inside the ECM. On/off time is modulated from 0 to 99 % dependent upon the exhaust back pressure desired.
Upon each initial engine start-up, the ECM exercises the exhaust back pressure valve by commanding it to cycle on and off once. If upon start-up the temperature of intake air sensed by the Intake Air Temperature (IAT) sensor is < 37°F (5°C) and the oil temperature sensed by the Engine Oil Temperature (EOT) sensor is between 32°-140°F (0-60°C) it will continue to keep the back pressure valve partially closed. As the oil temperature rises during engine operation, the ECM will control the valve in response to the rising oil temperature.
P0475 For specific makes
Need more help?
Need parts?