Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.
For some FORD models:
1. Disconnect the inertia switch harness connector
2. Turn key to ON position (Engine OFF)
3. Measure voltage of circuit between inertia switch harness connector and ground
4. If battery voltage is found, replaced Inertia Switch
5. Clear codes.
To diagnose the P0230 2009 Ford Fusion code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.
The code will be set if an incorrect voltage on the control circuit of the fuel pump relay is detected by the ECM.
The Powertrain Control Module (PCM) monitors the fuel pump (FP) circuit output from the PCM. The test fails when the FP output is commanded ON (grounded) and excessive current draw is detected on the FP circuit. The test also fails when the FP output is commanded OFF and voltage is not detected on the FP circuit. The PCM expects to detect VPWR voltage coming through the fuel pump relay coil to the FP circuit
Need more information on how to fix the P0230 2009 Ford Fusion code? Get Access to Factory Service Manuals
Get the P0230 2009 Ford Fusion code diagnosed by a professional: Find a repair shop in your area
Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0230 2009 Ford Fusion code? Have you replaced any parts?
Any information is appreciated. Thanks