Test HomeLink transceiver by pressing any button (red indicator light should come on)
2
Clear all channels by pressing both outside buttons at the same time on HomeLink and hold until red indicator light
blinks rapidly (approximately 20 seconds), then release.
3
Program HomeLink with your hand-held transceiver.
a
Press the button you want to program, and activate the hand-held transceiver until "red indicator light"
blinks 'slowly' (programming mode, hold buttons down).
4
Continue holding down HomeLink and hand-held transceiver buttons until red indicator light blinks 'rapidly' (this
may take 1-30 seconds), then release. You can now use HomeLink instead of you hand-held transceiver.
Note
If more transceiver needs to be program, repeat steps 3 and 4 in a different button on the sunvisor's HomeLink
DIY
