2009-2012 Infiniti FX In Cabin Micro Filter Replacement Procedure

Instructions

• 1
  Remove the instrument lower passenger panels and glove box.
• a
  Open the glove box.
• b
  Pull back glove box assembly (1).
• 
• c
  Remove damper pin (1) of left side.
• 
• d
  Remove instrument lower cover RH.
• 
• e
  Remove instrument lower panel RH.
• I
  Remove instrument lower panel RH (1) fixing screws (A).
• II
  Pull back instrument lower panel RH.
• 
• 2
  Remove the filter cover (1), then remove the in-cabin microfilter (2).
• 3
  Take out the in-cabin microfilter from blower unit.
• 4
  Replace with new one and reinstall on blower unit.
• 5
  Reinstall the instrument lower passenger panel.
• 
• Note:
• When installing a new microfilter make sure of the following:
  - The filter is installed so that the arrow, on the end of the filter, is facing the rear of the vehicle and is pointed upward.
  - The microfilter sits on top of the two black plastic tabs, not behind them.
  - The ledge on the back side of the microfilter cover panel slides below the microfilter.
• Note:
• If the microfilter is improperly installed, the ledge on the back side of the microfilter cover panel pushes directly into the microfilter, causing distortion. A distorted microfilter may interfere with the recirculation door.

Infiniti FX35 / FX45 / FX50 DIY Projects
Modifications	Engine & Transmission	Air Bag & Body Exterior/Interior	OEM Factory Accessories Installation Guides
Electrical, Audio & Navigation	Heater & Air Condition	Suspension, ABS, Brakes & Tires	Engine Control System